11.2 Setting the Cutting Height
Seven cutting heights can be set:
–
30 mm = position 1
–
40 mm = position 2
–
50 mm = position 3
–
55 mm = position 4
–
65 mm = position 5
–
70 mm = position 6
–
80 mm = position 7
The positions are indicated on the lawn mower.
Setting the cutting height
► Stop the engine.
The blade must not be turning.
► Place the lawn mower on a level surface.
► Pull lever (1) from the notch and move to the
desired position.
11.3 Switching the Drive On and Off
11.3.1 Engaging Self-propulsion
► Place the lawn mower on a level surface.
► Start the engine.
► Pull control bar for self-propulsion (1) fully in
the direction of the handlebar and hold so the
thumb encloses the handlebar.
The lawn mower starts moving.
11.3.2 Disengaging Self-propulsion
► Release the control bar for self-propulsion.
► Wait until the lawn mower comes to a stand‐
still.
11.4 Mowing
► If working with self-propulsion engaged: drive
the lawn mower forwards in a controlled man‐
ner.
► If working with self-propulsion disengaged:
push the lawn mower forwards slowly and in a
controlled manner.
11.5 Emptying the Grass Catcher
Box
The flow of air generated by the blade raises
level indicator (1). The flow of air stops when the
grass catcher box is full. If the flow of air is too
low, level indicator (1) returns to its resting state.
This is a prompt to empty grass catcher box (2).
The functionality of level indicator (1) is restricted
if the flow of air is impaired. External influences
such as wet, dense or high grass, low cutting
height, contamination or the like can impair the
flow of air and the functionality of level indica‐
tor (1).
English 11 Operating the Lawn Mower
30 0478-111-9849-A
To Next Page
Loading...
Need help?
General
