Subaru EH72 FI User Manual

- 9 -
20) COOLING FAN
Attach cooling fan onto flywheel.
M6 x 16 bolt & washer : 4 pcs.
21) THROTTLE BODY
(1) Replace the gasket of manifold with a new
one and mount the throttle body on the
intake manifold.
(2) Replace the gasket of throttle body with a
new one and mount the cleaner adapter on
the throttle body.
M6 FLANGE NUT : 4pcs.
(3) Connect the connectors from ECU to the injectors.
M6 x 30 bolt & washer : 4pcs.
(2) Connect wiring from ECU to the primary
terminal of ignition coil.
(3) Clamp the wiring harness with wire bands
to the intake manifold.
22) IGNITION COIL and WIRE CP
(1) Temporally fit ignition coil to crankcase.
Adjust air gap between ignition coil and flywheel using a thickness gauge and tighten bolts.
4-4 REASSEMBLY PROCEDURES (DIFFERENCE)
&22/,1*)$1
0%2/7DQG
:$6+(5SFV
GASKET
INJECTOR
WIRING
HARNESS #1
WIRING
HARNESS #2
THROTTLE
BODY
INTAKE
MANIFOLD
CLEANER
ADAPTER
GASKET
7+,&.1(66*$8*( ,*1,7,21&2,/
:,5(
Tightening torque
6.8 - 8.8 N•m
(70 - 90 kgf•cm)
(5.1 - 6.5 ft•lb.)
Tightening torque
6.8 - 8.8 N•m
(70 - 90 kgf•cm)
(5.1 - 6.5 ft•lb.)
Tightening torque
6.8 - 8.8 N•m
(70 - 90 kgf•cm)
(5.1 - 6.5 ft•lb.)
Ignition coil air gap
0.3 - 0.5 mm
(0.012 - 0.020 in.)

Subaru EH72 FI Specifications

General

Brand	Subaru
Model	EH72 FI
Category	Engine
Language	English