Operation Manual 6 LCD Menu Operation
21
Step 1
Tap “Function” from the default menu;
Step 2 Tap “Set-parameter” and the password entering window pops out;
Tap the white edit box and a keypad pops out.
Enter the password through the keypad.
− ←: backspace key, delete the digit input
− Clr: clear the digitals input
− Esc: escape and close the keypad
− Enter: confirm the password input
− Max./Min.: the maximum and minimum value can be input; digital outside this range is
invalid
If the input password is 1111, user can enter into the normal parameter setting page and set
the system parameters, running parameters, protection parameters and communication
parameters.
Step 3 Press “Enter” to confirm the password input.
Step 4 If the password is incorrect, an “Error password” window will appear. Tap “Enter” and re-enter the
password.
6.5 Language Setting
User can set the language by either of the following two ways:
Conventional Way
Step 1 Tap “Function” from the default menu;
Step 2 Tap “Set-parameter”;
Step 3 Tap “Sys-parameter” after entering the correct password;
To Next Page
Loading...
Need help?
General
