1
1
Safety Instructions
When installing, commissioning, operating, and maintaining the device, strictly observe rele-
vant safety instructions. Incorrect operation or work may cause:
• Injury or death to the operator or a third party.
• Damage to the device and other properties.
Strictly follow the safety instructions stated in the manual to avoid the hazards mentioned
above.
• The safety instructions in this manual are only supplements and cannot cover
all the precautions that should be followed. Perform operations considering ac-
tual on-site conditions.
• SUNGROW shall not be held liable for any damage caused by violation of gen-
eral safety operation requirements, general safety standards, or any safety in-
struction in this manual.
• When installing, operating, and maintaining the device, comply with local laws
and regulations The safety precautions in this manual are only supplements to
local laws and regulations.
1.1 Unpacking and Inspection
Check all safety signs, warning labels, and nameplates on products.
The safety signs, warning labels and nameplates must be clearly visible and can-
not be removed or covered before the product is decommissioned.
After receiving the product, check whether the appearance and structural parts of
the device are damaged, and check whether the product received is consistent
with the order. If there are problems with the above inspection items, do not install
the device and contact SUNGROW in time.
1.2 Installation Safety
Make sure there is no electrical connection before installation.
To Next Page
Loading...
Need help?
General
