LEFT HANDLEBAR
CLUTCH LEVER
@
The clutch lever is used for disengag-
ing the drive to the rear wheel when
starting the engine or shifting the
transmission gear. Squeezing the
lever disengages the clutch.
HEADLIGHT FLASHER SWITCH
Q
Press the switch to light the headlight.
The headlight high beam will be lit
when the dimmer switch is in
"LO"
position.
HAZARD WARNING SWITCH
@
All four turn signal lights and indica-
tors will flash simultaneously when
the switch is turned on with the igni-
tion switch in
"ON"
or "P" position.
Use the hazard warning lights to warn
other traffic during emergency park-
ing or when your vehicle could other-
wise become a traffic hazard.
DIMMER SWITCH
@
"LO"
position
The headlight low beam and taillight
turn on.
":D"
position
The headlight high beam and taillight
turn on. The high beam indicator light
also turns on.
IORN SWITCH
"b"
5
'ress the switch to sound the horn.
URN SIGNAL LIGHT SWITCH
@
loving the switch to the
'a"
position
fill flash the left turn signals. Moving
le switch to the
"0"
position will
ash the right turn signals. The indi-
ator light will also flash intermittently.
D
cancel turn signal operation, push
ie switch in.
Failure to use the turn signals, and
failure to turn off the turn signals
can be hazardous. Other drivers
may misjudge your course and
this may result in an accident.
Always use the turn signals when
you intend to change lanes or
make a turn. Be sure to turn off
the turn signals after completing
the turn or lane change.
To Next Page
Loading...
Need help?
General
