ENGINE STALLING
1. Make sure there is enough fuel in
the fuel tank.
2. If the coolant temperature meter
indicates "FI", showing signs of
trouble in the fuel injection sys-
tem, take your machine to an
authorized Suzuki dealer. Refer to
the "INSTRUMENT
PANELI' sec-
tion for fuel injection system indi-
cator explanation.
3.
Check the ignition system for
intermittent spark.
4. Check the idle speed. If neces-
sary, adjust it using a tachometer.
The correct idle speed is 1200
-
1400 rlmin.
I
MOTORCYCLE CLEANING
Washing the Motorcycle
When washing the motorcycle, follow
the instruction below:
1. Remove dirt and mud from the
motorcycle with running water.
You may use a soft sponge or
brush. Do not use hard materials
which can scratch the paint.
2. Wash the entire motorcycle with a
mild detergent or car wash soap
using a sponge or soft cloth. The
sponge or cloth should be fre-
quently soaked in the soap
sdu-
tion.
CAUTION
~adiator and oil cooler fins can be
damaged by spraying high pres-
sure water on them.
Do not spray high pressure water
on the radiator and oil cooler fins.
NOTE:
Avoid spraying or allowing
water to flow over the following
places:
Ignition switch
Spark plugs
Fuel tank cap
Fuel injection system
Brake master cylinders
3.
Once the dirt has been completely
removed, rinse off the detergent
with running water.
4. After rinsing, wipe off the motorcy-
cle with a wet chamois or cloth
and allow it to dry in the shade.
To Next Page
Loading...
Need help?
General
