ELECTRIC STARTER BUlTON
"a'
0
This button is used for operating th
starter motor. With the ignition switc
in the
"ON"
position, the engine sto
switch in
"C)" and the transmission i
neutral, push the electric starter bu
ton to operate the starter motor an
start the engine.
NOTE: This motorcycle is equippe
with interlock switches for the ignitio
circuit and the starter circuit. Th
engine can only be started if:
The transmission is in neutral an
the clutch is disengaged, or
The transmission is in gear, th
side stand is fully up and th
clutch is disengaged.
CAUTION
To prevent electrical system dam-
age, do not operate the starter
motor more than five seconds at a
time.
If the engine does not start after
several attempts, check the fuel
supply and ignition system. Refer
to the TROUBLESHOOTING sec-
tion in this manual.
Engine speed is controlled by the
position of the throttle grip. Twist it
toward you to increase engine speed.
Turn it away from you to decrease the
engine speed.
THROlTLE GRIP
@l
~
3
To Next Page
Loading...
