Suzuki DL650 User Manual

8. Smear a little engine oil aroun
the rubber gasket
@ of the new o
filter.
9. Screw the new filter by hand unt
the filter gasket contacts thl
mounting surface (a small resis
tance will be felt).
I CAUTION
Using an oil filter with the wrong
design or thread specifications
can cause oil leaks
or engine dam-
age.
Use
a genuine SUZUKl oil filter or
an equivalent designed for your
motorcycle.
NOTE: To tighten the oil filter properl]
it is important to accurately identji
the position at which the filter gaskt
first contacts the mounting surface.
Mark top dead center
I
Oil filter wrench
\@
In the position at
which the filter
gasket first contacts
the mounting
surface.
10. Mark the top dead center position
on the "cap type" filter wrench or
on the oil filter. Use an oil filter
wrench to tighten the filter 2 turns.
11. Pour 2700
ml (2.912.4 USllmp. qt)
of new engine oil through the filler
hole and install the filler cap. Be
sure to always use the specified
engine oil described in the FUEL
AND ENGINE OIL section.

Suzuki DL650 Specifications

General

Displacement	645cc
Compression Ratio	11.2:1
Fuel System	Fuel injection
Transmission	6-speed constant mesh
Front Suspension	Telescopic, coil spring, oil damped
Rear Suspension	Link type, coil spring, oil damped
Starter	Electric
Final Drive	Chain
Engine Type	4-stroke, liquid-cooled, DOHC, 90° V-twin
Bore x Stroke	81.0mm x 62.6mm
Front Brakes	Disc
Rear Brakes	Disc
Front Tire	110/80R19M/C 59H
Rear Tire	150/70R17M/C 69H
Overall Width	835mm
Overall Height	1405mm
Ground Clearance	170mm
Seat Height	835mm
Fuel Tank Capacity	20.0L