3-33
OPERATING YOUR VEHICLE
83RM0-01E
4) Remove the cover (1) over the button.
5) While pushing the release button at the
bottom of the removed cover (1) by the
key or the flat end rod, push the knob
button (2) and shift the gearshift lever to
the desired position.
This procedure is for emergency use only.
If repeated use of this procedure is neces-
sary, or the procedure does not work as
described, consult your SUZUKI dealer or
a roadside assistance service.
Right Hand Drive Vehicle
61MM452
Vehicles with a TCSS have an electrically
operated park-lock feature. If the vehicle’s
battery is discharged, or there is some
other electrical failure, the TCSS cannot be
shifted out of Park in the normal way. Jump
starting may correct the condition. If not,
follow the procedure described below. This
procedure will permit shifting the transaxle
out of Park.
1) Be sure the parking brake is firmly
applied.
2) If the engine is running, stop the
engine.
3) Make sure the ignition mode is “ON” or
“ACC”.
4) While pushing the release button (1),
push the knob button (2) and shift the
gearshift lever to the desired position.
This procedure is for emergency use only.
If repeated use of this procedure is neces-
sary, or the procedure does not work as
described, consult your SUZUKI dealer or
a roadside assistance service.
Gearshift Indicator
61MM0A133
(1) Gearshift indicator
In the following cases, the gearshift indica-
tor is indicated on the information display
when the ignition switch is in the “ON”
position or the ignition mode is “ON”.
• For manual transaxle vehicle, when the
gearshift lever is in a position other than
“N” (Neutral).
• For automatic transaxle or TCSS vehi-
cle, when using the manual mode.
• For vehicles equipped with the cruise
control, when the system is not in use.
• For vehicles equipped with the radar
brake support system, when the forward
collision warning is not working.
(1)
(2)
To Next Page
Loading...
Need help?
General
