3-61
OPERATING YOUR VEHICLE
83RM0-01E
Cancellation of the Speed Limiter
• To cancel the speed limiter, push the
“CANCEL” switch (2). The set indicator
(6) will go off.
• To resume the previously set speed,
push the “RES +” switch (3) and turn on
the set indicator (6).
To turn off the speed limiter system, push
the speed limiter switch (1) and make sure
the limit indicator (5) is off.
Also, you can turn off the speed limiter by
turning off the engine.
NOTE:
If you turn off the speed limiter system, the
previously set speed in the memory is
cleared. Set your speed again.
Parking Sensors (if equipped)
61MM0A192
(1) Symbol representing an obstacle
detected by parking sensor*
* This symbol represents an obstacle
that is located to the right rear at
the vehicle.
• The parking sensor system uses ultra-
sonic sensors to detect obstacles near
the front and rear bumpers. If obstacles
are sensed while you are parking or
moving the vehicle slowly, the system
warns you by sounding a buzzer and
displaying symbols representing the
obstacles on the information display in
the instrument cluster.
• The system emits an ultrasonic wave
and the relevant sensor detects the
return of the wave reflected by an obsta-
cle. The system measures the time
taken by the ultrasonic wave to reach the
obstacle and return from it, from which it
determines the obstacle’s position.
• The parking sensor function can be used
when you press the engine switch to
change the ignition mode to “ON”, the
gearshift lever is in a position other than
“P” (for automatic transaxle or TCSS
models) and the parking sensor switch is
in the “ON” position. This function is
helpful in the following cases: pulling
over to the curb; parallel-parking the
vehicle; steering the vehicle into a
garage; driving along an alley; and mov-
ing slowly in a place with obstacles.
WARNING
• The parking sensor warns you of
obstacles with buzzers and by
showing you the location of the
obstacles on the information dis-
play. However, you must still pay
full attention yourself while driving.
• The sensors can detect obstacles
only within a limited area and only
when the vehicle is moving within a
limited speed range. So, in tricky
areas, you must move the vehicle
slowly while checking around it
using your direct vision or rearview
mirrors. There is increased risk of
an accident if you control the vehi-
cle relying only on the parking sen-
sor.