9
Engine stop switch
When the ignition switch key is turned to this position, press the electrical starter button, the
engine can be started.
When the ignition switch key is turned to this position, press the electrical starter button , the
engine can not be started.
Electrical starter button
This is a starting motor button (switch) for engine starting.
With the main switch “on”, press this button while holding the front or rear brake lever will start
the engine.
CAUTION:
Release this button immediately after engine has been starter, and never press the button again
to avoid damaging the engine.
This mechanism is a safety design. The engine can only be started after the front or rear brake
lever (pedal) has been applied.
Do not use light system. Turn headlight and turn signal light to the “off” position when the engine
is being started.
High/low beam switch
This is the high and low beam of headlight switching switch. Press this switch to switch between high
and beams.
This is for high beam.
This is for low beam.(please turn to low beam riding in city.)
To Next Page
Loading...
Need help?
General
