CHECKING AND CHANGING FUSES
Fuse box is on the frame body, remove the luggage box then you can see the fuse box is on the frame body
right side. Turn off ignition switch, and check fuses if they are intact. Replace the blown fuse with a new
one having the same specified amperage rating (20A or 15A or 10A). Using a fuse which the amperes is
larger than specification, a brass or iron wire to replace a blown fuse is strictly prohibited to avoid damaging
the electrical system and the circuit.
• Remove the storage box, and you’ll find the fuse box near light.
• Open the fuse box cover, and pull out the fuse. Check it for damage or broken.
• Fuses must be firmly secured with wire connectors when replacing. Loose connections will result in
overhead and damage.
• Use only parts having the specified specification to replace electrical components such as light bulbs.
Using parts not having the specified specifications for replacement may cause the fuse to blow and
over-discharge the battery.
• Avoid spraying water directly on or around fuse box when washing the scooter.
• Take your scooter to your dealer for an inspection if a fuse is blown by unknown causes.
CHECKING THE TURN SIGNAL LIGHTS AND HORN
• Turn the ignition switch key to “ON” position.
• Turn on the turn signal light switch, and make sure that the front & rear and left & right signal lights flashes
and also check if the warning buzzer sounds.
• Check turn signal light covers if they are dirty, crack, or loosen.
• Press horn button to check if it works.
CAUTION:
! Use only specified bulbs for turn signal lights. Otherwise, the normal operation of turn signal lights will be
affected.
! Switch on the turn signal before changing lanes or marking a turn to inform others of your intent.
! After changing lanes or making a turn, switch of turn signal immediately by pressing the reset button.
This button is located in the center of the turn signal switch.
CHECKING THE HEADLIGHT AND TAIL LIGHT
• Start engine and turn on the headlight switch. Check if headlight and tail light come on.
• Check the brightness and direction of headlight by wall to see if it is correct.
• Check the headlight cover if it is dirty, crack, or loosen.
To Next Page
Loading...
Need help?
General
