•
Side Stand warning indicator：
When the side stand pulls down , the warning indicator tights on and the engine cannot be started ,when
the side stand raises up ,the indicator goes out and the engine can be started.
CAUTION:
Make sure the side stand is completely retrieved before riding to preventing causing danger.
• Odometer：
This odometer shows the total kilometers this scooter has been driven.
Total kilometer : This shows the total kilometers of this scooter. It shows six digits; 5 in kilometers and 1 in
hundred meter. (The total kilometer will return to zero if it runs over 100,000 kilometers.)
Trip kilometer : The rider can measure the trip kilometers. It shows four digits; 3 in kilometers and 1 in
hundred meter. (The trip kilometer will return to zero if its measurement is over 1,000 kilometers.)
• Engine Coolant Temperature
To indicate engine coolant temperature.
When the main switch turns to “ON”, the LCD and the water temperature indicator keeps coming on.
Normally, the LCD indicator should be below the (H) position when the scooter is operating. If the LCD
indicator stays above (H) position, the water temperature indicator flashes. Please check the coolant level
of spare coolant tank and check cooling fan for proper operation.
CAUTION:
The indicator will stay above (H) position when engine is run under high temperature for a long period
of time. In this case, the only way to cool the engine is to stop the engine.
• Time setting
Set time in 24 hour mode.
When the main switch turns to “ON” the clock shows hours and minutes in 24 hour mode.
At this “Time mode” press HOUR and MIN bottom at the same time, and enter the “Time setting mode”.
At this moment the time digit flashes: press the HOUR bottom once and the hour increases. Keeping on
pressing for 2 seconds can accelerate the adjustment. (The minute adjustment by MIN bottom is the
same like this.)
At “Time setting mode” press HOUR bottom and this bottom will not flash for 2 seconds. (The same as
MIN bottom.)
When time setting completed. Press ALARM bottom or without pressing HOUR or min bottom for 3
seconds to exit “Time setting mode”.
7
7. Use of each component
To Next Page
Loading...
Need help?
General
