TB8100 Installation Guide Installation 7
© Tait Electronics Limited February 2007
3. Fit a surge suppressor to the antenna cabling where it enters the
building.
4. Inspect all cables and equipment connected to the TB8100 base
station for defects.
1.2.3 Equipment Grounding
To ensure safe operation the TB8100 base station equipment must be
correctly grounded as described in these installation instructions.
1.2.4 Installation and Servicing Personnel
The TB8100 base station should be installed and serviced only by qualified
personnel.
1.3 Regulatory Information
1.3.1 Distress Frequencies
The 406 to 406.1MHz frequency range is reserved worldwide for use by
Distress Beacons. Do not program transmitters to operate in this frequency
range.
1.3.2 FCC Compliance
1
This device complies with part 15 of the FCC Rules. Operation is subject
to the condition that this device does not cause harmful interference.
1.3.3 Unauthorised Modifications
Any modifications you make to this equipment which are not authorised by
Tait Electronics Limited may invalidate your compliance authority’s approval
to operate the equipment.
1.3.4 Health, Safety and Electromagnetic Compatibility in Europe
In the European Community, radio and telecommunications equipment is
regulated by Directive 1999/5/EC, also known as the Radio and
Te l e c o m m u n i c a t i o n s Te r m i n a l E q u i pment (R&TTE) directive. The
1. Refer to the TB8100 Specifications Manual (MBA-00001-xx) for more information on the
compliance standards to which the TB8100 base station equipment has been tested and approved.
To Next Page
Loading...
Need help?
General
