Midian Encryption Programming and Service Manual Tait Orca Portable (TOP) Encryption 31
June 2006 © Tait Electronics Limited
Note If the radio displays 'DBASE ERROR', reload the saved
programming data file
Note If the radio displays 'CALIBRATION ERROR', reload the saved
calibration data file.
7. Power-off radio, power-on with PTT pressed, and check firmware
version is correct.
Install and Run Encrypted Radio Programming Software on PC
This procedure requires:
■ TOPA-SV-116 Programming Kit
■ Encrypted Radio Programming Software
1. Unzip the Programming Software file in the directory that you want
to run it from.
2. Run the *.exe file.
Encrypted Radio Programming Software Settings
1. In the Specification form set the Maximum Number of Encryp-
tion Codes
to a number between 1 and 16.
2. In the
Key Settings form, choose a function key to
assign to
Encryption On/Off and another for Encryption Code
Select
.
The available function keys are:
■ Function Key 1 (long or short press)
■ Function Key 2 (long or short press)
■ Function Key 3 (short press)
■ Short Menu key (long press)
■ External Function Key 1
■ External Function Key 2
3. In the
User Defined Menu form, check the ENCRYPT SETTINGS
box (ticking a top-level menu enables all of that menu's submenu
functions). This means that Encryption (on/off and code selection)
will be available from the radio menu.
3.4 Encryption Module Programming
The Midian VPU-12 module is preprogrammed by the manufacturer and
does not normally require programming. Its programmable functions can be
programmed by open-radio direct programming. It does not support
OTAR programming.
To Next Page
Loading...
Need help?
General
