22
Overview
1 Cord support
2 Power outlet 700W (except for ergodisc 200/238)
3 Power supply cord
4 Central steel pillar
5 Additional equipment holder
6 Cable hook (not standard ex-factory for all models)
7 Wheels
8 Tools (brush, pad drive, etc.)
9 Brush cover
10 Motor ventilation
11 Spray valve connector
12 Central water and spray inlet
13 Selection switch 165/330 rpm (only duo)
14 Recessed grip (for transportation)
15 Height adjustment lever
16 Safety switch
17 Right operating lever (Motor ON/OFF)
18 Machine handle
19 On Iight (Plugged into mains socket)
20 Tool holder (Brushes, pads)
21 Push button for electrical spray unit (except for ergodisc 200/238)
22 Operating lever left (Motor ON/OFF)
23 Action lever for mechanical spray unit and water outlet tank
Machine installation
Attaching tools
Check:
• that the brush has not fallen below the red mark or a brush length of 1 cm.
• the pad for wear and foreign bodies (e.g. grains of sans) before use.
• that the tool is mounted.
Could cause damage to floor surface by negligence!
Recommended chemicals
Only use the chemical products recommended by the manufacturer.
The correct dosage is recommended on the product's packaging and on the "
TASKI Product Information Sheet".
14151618 1317
1
2
3
4
5
678 9
10
11
12
1920212223
• Lay the tool on the floor in front of the machine.
• Stand behind the machine.
• Pull the height adjustment lever on the machine
handle and slowly lower the guide pillar into a
comfortable working position, making sure your
arms are almost straight.
• Let go of the height adjustment lever, the guide
pillar will locate into place and stay at that angle.
• Tilt the machine back slightly and position it
over the tool until it touches the back of the tool
unit.
• Return the machine to its upright position.
• Move the machine from left to right until the tool
locates into place.
Now the machine is ready for use.
Caution:
Using other chemicals (e.g. chemicals containing solvents,
chlorine, hydrochloric acid and hydrofluoric acid) can damage or
destroy the machine.
To Next Page
Loading...
Need help?
General
