OPERATING PROCEDURES
6-7
Models C709 & C717
Operating Procedures
6
Note: Make sure the hole in the air orifice is clean
and is not clogged. If the hole in the air orifice should
become clogged, use soap and hot water to clear the
hole. Do not enlarge the hole in the air orifice.
3. Install the air orifice into the hole in the top of the feed
tube (end without the mix delivery hole on the side).
Figure 6-28
4. Lay the feed tube (with the air orifice installed) and
the agitator in the bottom of the mix hopper for
sanitizing.
Figure 6-29
5. Repeat steps 1 through 4 for the other side of the
C717.
Install Drip Pans and Splash Shield
1. Model C709: Slide the drip pan into the hole in the
left panel.
Model C717: Slide the long drip pan into the hole in
the front panel. Slide the other two drip pans into the
holes in the side panels. (See Figure 6-30.)
Figure 6-30
2. Install the front drip tray and splash shield under the
door spout(s). (
See Figure 6-31.)
Figure 6-31
Sanitizing
1. Prepare a 2-1/2 gal. (9.5 L) pail of a Taylor-approved
cleaning/sanitizing solution with an active chlorine
concentrate of 100 PPM–200 PPM (examples: 2 gal.
[7.6 L] of Stera-Sheen
®
or 2-1/2 gal. [9.5 L] of
Kay-5
®
).
Important! Use warm water and follow the
cleaning/sanitizing solution manufacturer's
specifications.
To Next Page
Loading...
Need help?
General
