TC-Helicon VOICELIVE Touch User Manual

6
Mounting to a Mic Stand
MIC STAND SETUP
1. With no cables attached to the product, grasp it on both sides so
the printed top faces you and is approximately level.
2. Slide VoiceLive Touch to the left so that the upper shaft of your
mic stand is captured by the lower slot on the product. (Figure 1)
3. Slowly but firmly lower the front of the product so the serrated
slot fully captures the micstand shaft. (Figure 2) You’ll feel initial
resistance then the shaft should snap in and seat tightly.
Removal is the reverse: lift the front of the product so it snaps free of the
micstand shaft then slide right to remove.
Note that micstand diameter should not exceed 16.5 mm.
CABLING
The horizontal mounting slot on VoiceLive Touch is also used to collect
your cables. As shown in the graphic below, cables can be threaded
through the slot. Use the provided cable wrap to tie your cables neatly
to your micstand.

TC-Helicon VOICELIVE Touch Specifications

General

Brand	TC-Helicon
Model	VOICELIVE Touch
Category	Recording Equipment
Language	English