TCL 43P6US User Manual

9
Network Settings
You can set up your TV so that it can access the Internet through your local area network (LAN) using a wired or
wireless connection.
Connecting to a Wired Network
1. Press on the remote control, select Network > Wired settings and press OK/► to enter.
2. Check the network information or enter IP settings to set the IP address, Subnet mask, Default gateway and
Primary DNS values manually. Then press ▲/▼/◄/► to select OK and press OK to conrm. The TV set will try
to connect to the network and inform you about the result.
3. Press
to return to the Network menu.
4. If you want to check the Internet connectivity, press ▲/▼ to select Connecting test and press OK/►.
Connecting to a Wireless Network
Your TV is equipped to be connected to your home network wirelessly. To do that you need a wireless router or
modem.
1. Press
on the remote control, select Network > Wireless connection> Wireless connection and press OK/►
to enter.
2. Press ▲/▼ to select On and press OK to conrm.
3. You can set the wireless network connection in 3 ways:
- a) Scan
• When Wireless connection is turned on, the TV will search all access points within range. Access points
found by the TV will be displayed.
• Press ▲/▼ to select an available access point, then press OK/► to connect.
• Select All wireless (if available) to nd more access points.
Note: If you select a protected access point, you will have to enter the corresponding password. Press OK on the
remote control to display the virtual keyboard to enable you to enter the password.
- b) Manual
Press ▲/▼ to select Manual and press OK/► to enter. You will be prompted to enter the correct SSID of an
available wireless router, select its security tytpe and enter the password (if needed) to set up the connection.
- c) Auto
If your AP (Access Point) supports WPS (Wi-Fi Protected Setup), you can connect to the network via PIN
(Personal Identication Number) or PBC (Push Button Conguration). WPS will automatically congure the
SSID and WPA key in either mode.
Press ▲/▼ to select Auto and press OK/► to enter.
• PIN: Select PIN and press OK/► to enter. Choose a random PIN code. Make sure this code is installed on the
AP. (For the procedures, refer to your router manual.) Select OK and press OK to set up the connection.
• PBC: If your router has a PBC push button, select PBC and press OK/► to enter. Press the PBC push button
on your router within 2 minutes before you select OK and press OK again. Your TV will automatically acquire
all the network setting values it needs and connect to your network.
- Press
to return to the Network menu.
4. If you want to check the Internet connectivity, press ▲/▼ to select Connecting test and press OK/►.
Chapter 2 Getting Started

TCL 43P6US Specifications

General

Brand	TCL
Model	43P6US
Category	LED TV
Language	English