11
Getting Started
Initial Setup
The rst time you switch the set on, the
Welcome
wizard
appears, which guides you through the initial setup
process. Follow the on-screen instructions to nish the initial setup process such as selecting the language, pairing
your remote, connecting to the network, and more. During each step, either make a choice or skip the step. If you
skip a step, you can perform the setup later from the settings menu.
Notes:
- It's recommended to select
Set up Google TV
and finish its setup to enjoy more features during the initial setup
process. If you have finished basic TV's setup, you can reaccess Google TV by pressing on the remote control,
selecting
(Settings) > Set up Google TV
and pressing
OK
to confirm.
- When you pair your remote, keep the remote control and TV within 1 meter, and follow the on-screen guide for
pairing. After finishing pairing the remote, you can use the Google Assistant button. If you skip remote pairing, you
will be prompted to pair the remote with the TV again when you use the Google Assistant button for the first time.
TV Buttons
-
Power button
If the batteries in your remote control are run down, you can use the button on your TV set.
The model has only one button. It may work just as Standby/Quit standby button, or as a multi-function
controller.
You can turn on the TV by pressing the button on the TV set.
While the TV is on, press the button to display the multi-function menu. For more information about how to use
the multi-function menu, please refer to the figure below.
CH+ CH- Volume+
Source OKVolume-
Standby
Tips: Short click to change, long click to select.
• Press to move the highlight to the next function selection
• Press and hold the button for more than 2 seconds to conrm your selection.
Note:
- The button is located at the bottom of the TV or at the bottom left of the TV back case, depending on the
model.
- You can follow the on-screen guide to operate. Figures and illustrations are provided for reference only and may
vary depending on the model.
-
MIC switch
ON
OFF
The MIC switch is located next to the power button. If you want to use the feature of hands-free TV voice control,
turn on the switch.
Network Settings
After you connect your home network to the TV, follow the steps below to enter the
Network & Internet
menu.
1.
Press on the remote control to display the dashboard menu.
2.
Select
(Settings)
and press
OK
to enter the settings menu.
3.
Press
Up/Down
to select
Network & Internet
, then press
OK
to enter the submenu and follow the on-screen
guidance to set up your network.
To Next Page
Loading...
Need help?
General
