11
WPS Settings
WPS is a wireless network security standard that tries to make connections between your
LinkZone and wireless devices faster and easier.
If your wireless device is WPS-supported, you can access the LinkZone Wi-Fi network
through a WPS connection.
WPS Switch
Select Enabled to enable WPS function, and Disabled to disable
WPS function.
Add new device
There are two ways to add a new device, you can choose PIN or
PBC, details see '2.3 Access LinkZone network' on page 4.
MAC Filter
You can specify which device can or cannot access the internet.
Advanced Settings
Network Mode
The mode is set to 802.11b/g/n by default.
Channel
Bandwidth
You can select from the available options via the drop-down menu.
This is set to Auto by default.
Country/Region
Code
You can select the suitable country/region code for your device.
Frequency
(Channel)
Select appropiate channel to optimize the performance and coverage
of your wireless work. This is set to Auto by default.
4.4 SMS
In this section, click Device to check the messages saved in device, and click SIM to check
the messages saved in the SIM card.
Refer to the following table for commonly used operations of SMS messages.
Read a message Click the message to expand it.
Send a message
1. Click New.
2. Input the recipient's number and message content.
3. Click Send.
Reply to a message
1. Click the message you want to reply to.
2. Input the message content, then click Reply.
Delete a message
1. Tick the box in the far left column for the message(s) that
you wish to delete.
2. Click Delete.
Delete all messages
1. Tick the box at the top left.
2. Click Delete.
To Next Page
Loading...
Need help?
General
