Factory Test & Alignment Specification For MT56 Series (V1.0)
12
the ID. There are two methods to modify the ID:
Change Project ID in Design Menu
In case of “Design mode hotkey” is enabled, press “Back” button to enter Design Menu. To modify
Project ID, you need to go through “Service menuProject ID”, then press Left or Right key to
select suitable ID (Project name is dynamically refreshed). Finally restart the TV set.
In case of “Design mode hotkey” is unabled, you can enter the Design Menu easily with reference
to 3.1 Design Menu.
Change Project ID with RCU
Press “062598”+”Menu”+”XXX” (XXX represents project ID you’d like to switch to) in the remote
control and wait about half minutes, When the set restart automatically, you have successfully
changed project ID.
Here below is none exhaustive ProjectID table for reference:
4.3 Function Test
Once the Project ID is correct and the TV display normally, plug all external generator devices to relevant
inputs/outputs below according to their respective test patterns format and check picture content and
sound quality accordingly:
RF Input
(PAL/DVB/DVB-T2)
PAL Half Color & Gray bars
Chroma/QuantumData
generator
1024x768@60Hz
Half Color & Gray bars
To Next Page
Loading...
Need help?
General
