Technics SC-CH717 User Manual

Manual tuner operation
JII
1 4 2 3
POWER
STANDBY Switch on the power on the
S_N amplifier.
_ Press TUNER/BAND to select
FM or AM.
Each time you press TUNER/BAND,
"FM", "AM" will be displayed in order.
,'/; ...................--.0.,.o
.-, J.-t _ (-j 4,J-)........
_ Press • or • to tune into the
desired broadcast.
The display will show the frequency
".9 which you selected.
_UM[ MUL_ CONTROL
• -- -- TUN_
ST_neo I_ I'--/ I 4_----PnESET
VOLUME Adjust the volume as you like
oo_///_\_,_._p on the amplifier.
Memory tuner operation
Switch on the power and be sure you've completed the steps of
"Automatic memory presetting" on page 17 or "Manual memory
presetting" on page 18.
This example shows how to tune in to the preset channel 1.
(2222_ Q2222)
Press <1 or • to select the de-
sired preset channel.
The selected preset channel will appear
on the display.
s,_.Eo n I_ I c_ _ I,-}-P........
'-" J--__-_ i -., , .....
Preset channel
FM MODE
If noise is excessive in the FM
mode:
Press FM MODE on the remote control.
.o.or._ Lights.
,-"h_ n i_ _ _ .o= ...... _,_,_.u_..o_.
The sound will then be heard in monau-
ral. If the broadcast signal is weak, or if
there is a large amount of interference,
you will get a clearer sound using FM
MODE.
AM allocation settings:
This unit comes equipped with an electronic digital tuner that divides
the broadcast band into many small steps. These steps match the
assignable broadcast frequencies and intervals in between.
Each country allocates (assigns) broadcast bands according to their
particular needs.
By adjusting the allocation, you can enable this tuner to receive AM
broadcasts allocated in 9 kHz steps.
1. Press TUNER/BAND to select AM.
2. Press and hold TUNER/BAND for approximately 4 seconds.
To return to the original frequency indication, repeat steps 1 and 2.
25

Technics SC-CH717 Specifications