EasyManuals Logo
Home>Technics>Speaker System>SC-EH580

Technics SC-EH580 User Manual

Technics SC-EH580
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
19
RQT6301
Basic operations
Cassette tapes
See page 39 for tape selection.
Preparation: Press [ê/I] to turn the unit on.
1 Press [< OPEN] on deck 1 or deck 2 and insert
the cassette.
Close the holder by hand.
2 Press [DOLBY NR] to select Dolby NR on
(“ëNR” appears) or off.
3 Press [REV MODE] to select the reverse mode.
Each time you press the button:
b: One side is played.
d: Both sides are played.
f: Both sides are played 8 times each.
4 Press ["] (reverse side) or [!] (forward side).
Play begins and the indicator changes to green.
5 Adjust the volume.
To stop the tape
Press [º].
[A] To change the deck to be used
Press [DECK 1/2] to select the deck you want to play.
To listen to 2 tapes consecutively
Insert a tape into each deck and select f. Both tapes will be played
8 times each.
»B
Finding a place on a tape
To fast-forward and rewind
Press [6] or [5] while the tape is stopped.
To find the beginning of a track (TPS: Tape program sensor)
Press [6] or [5] during play.
Play resumes from the beginning.
Manufactured under license from Dolby Laboratories.
Dolby and the double-D symbol are trademarks of Dolby
Laboratories.
³Each decks play direction is stored in the systems memory.
³You can fast-forward or rewind the tape while you are playing or recording
a tape in another deck.
Press [DECK 1/2] to switch to the deck not playing, and then press
[6] or [5]. After the above operation, be sure to press [DECK 1/2] to
reselect the deck playing.
Note
TPS may not operate correctly in the following situations:
If the interval between tracks is less than 4 seconds.
If there is noise between tracks.
If there are silent parts within tracks.
Dolby noise reduction
Dolby NR reduces hissing when playing tapes. It increases the high fre-
quency region when recording and then reduces it in playback. Use the
same system during playback and recording. This unit has Dolby B NR
which reduces noise to a third.
Prerecorded cassettes and equipment marked ëNR use Dolby B NR.
Tape direction rewind fast-forward
!65
"56
A
B
1
2
3
4
5
DECK 1/2
DOLBY NR
REV MODE
<
OPEN
76
114
6
,
5
23
DECK 1/2
Í/I
5
VOLUME
UP
DOWN
-- dB
MIN
0 dB
MAX
NR
1
Î
NR
Î
2
1
Î
NR
DECK 1 DECK 2
Forward side
Tape facing down
Tape direction

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Technics SC-EH580 and is the answer not in the manual?

Technics SC-EH580 Specifications

FRONT SPEAKER

Speaker Specifications IconSpeaker Specifications
super woofer size17 cm cone type
woofer size12 cm cone type
midrange size12 cm cone type
Electrical Characteristics IconElectrical Characteristics
impedance (high)6 �
impedance (low)8 �
input power (music, high)60 W
General IconGeneral
dimensions240�412�259 mm
mass5.8 k�
output sound pressure level87 dB/W (1.0 m)

CENTER SPEAKER

Speaker Specifications IconSpeaker Specifications
woofer size8 cm cone type
tweeter size6 cm cone type
impedance8 �
Electrical Characteristics IconElectrical Characteristics
input power (music)160 W
output sound pressure level86 dB/W (1.0 m)
crossover frequency4 kHz
General IconGeneral
dimensions190�99�166 mm
mass1.8 k�
frequency range100 Hz–22 kHz (�16 dB)

SURROUND SPEAKER

Speaker Specifications IconSpeaker Specifications
full range size8 cm cone type
impedance8 �
input power (music)70 W
General IconGeneral
dimensions140�99�118 mm
mass0.9 k�
output sound pressure level84 dB/W (1.0 m)

SOUND PROCESSOR

EQ/SFP Section IconEQ/SFP Section
center frequency (5-band EQ)70/300/1 k/3.15 k/10 k Hz
level control�2.0, 4.0, 6.0 dB
center frequency (3-band EQ)70/1 k/10 k Hz
Pre-amplifier Section IconPre-amplifier Section
input sensitivity/impedance (VCR)250 mV/15 k�
input sensitivity/impedance (AUX)250 mV/15 k�
output level (VCR REC OUT)150 mV/1.5 k�
General IconGeneral
dimensions293�89�270 mm
mass1.5 k�
delay time20 ms (Fixed)

TUNER AMPLIFIER

Amplifier Section IconAmplifier Section
power output (stereo mode, DIN)2�25 W (1 kHz THD 1 %/6 �)
power output (pro logic mode, DIN)2�25 W (FRONT 1 kHz THD 1 %/6 �)
power output (surround)2�30 W (1 kHz THD 1 %/8 �)
FM Tuner Section IconFM Tuner Section
frequency range87.50–108.00 MHz
sensitivity1.8 �V (IHF usable)
S/N MONO70 dB (75 dB, IHF)
General IconGeneral
power supply (UK, Australia, NZ)AC 230–240 V 50 Hz
power consumption190 W
standby power consumption0.5 W

CD PLAYER

General IconGeneral
dimensions293�89�288 mm
mass2.2 k�
wavelength780 nm

CASSETTE DECK

Deck Specifications IconDeck Specifications
deck systemStereo cassette deck
track system4 track, 2 channel
recording systemAC bias
General IconGeneral
dimensions294�118.5�281 mm
mass2.1 k�
tape speed4.8 cm/s

Related product manuals