Troubleshooting guide
Before requesting service for this unit, check the chart below for a possible cause of the problem you are experiencing. Some simple checks or a
minor adjustment on your part may eliminate the problem and restore proper operation.
If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem, refer to the directory of
Authorized Service Centers (enclosed with this unit) to locate a convenient service center, or consult your dealer for instructions.
Umweltfreundlich gedruckt auf chlorfreigebleichtem Papier.
Environment friendly printed on chlorine free bleached paper.
Matsushita Electric Industrial Co., Ltd.
Osaka 542-8588, Japan
RQT5414-B
M0300TK0
Specifications
•Audio
No. of channels 2 (left and right, stereo)
Frequency response 2–20,000 Hz, ±0.3 dB
Output voltage 2 V (at 0 dB)
Dynamic range 100 dB
S/N 115 dB
Harmonic distortion
([DIGITAL RE-MASTER PROCESSING] OFF)
0.0018% (1 kHz, 0 dB)
Total harmonic distortion
([DIGITAL RE-MASTER PROCESSING] OFF)
0.0023% (1 kHz, 0 dB)
Wow and flutter Below measurable limit
DA converter MASH (1 bit)
Output impedance Approximate 600 Ω
Load impedance More than 10 kΩ
Headphone output level 15 mW max. 32 Ω (adjustable)
•Pickup
Wavelength 780 nm
Laser Power No hazardous radiation is emitted
•General
Power supply AC 230–240 V, 50 Hz
Power consumption 15 W
Dimensions (W
X
H
X
D) 430
X
114
X
290 mm
Mass 4.0 k
Specifications are subject to change without notice.
Mass and dimensions are approximate.
Problem
After inserting a disc, the tray
will not close even after
pressing [ OPEN/CLOSE].
Even after inserting a disc,
the total number of tracks
and other indicators do not
appear on the display.
Even after pressing [ ], disc
play does not begin.
Specific areas do not play
properly.
The remote control does not
work.
Probable cause(s)
Is the disc inserted properly ?
Is the disc inserted upside-down ?
Is the disc dirty ?
Is the disc scratched ?
Is the disc extremely warped ?
Are you using a non-standard disc ?
Has moisture condensed in the unit ?
Is the disc dirty ?
Are the batteries inserted with the and
ends reversed ?
Are the batteries worn out ?
Suggested remedy
Re-insert the disc.
Re-insert the disc.
Wipe with a soft cloth.
Use another disc.
Wait an hour before using.
Wipe with a soft cloth.
Insert with and oriented correctly.
Replace batteries.
Reference
page(s)
7
7
15
15
5
5
En
To Previous Page
Loading...
Need help?
General