RQT5414
9
1
2
3
123
121110
98765432
1
PROGRAM
TRACK No.
121110
98765432
1
PROGRAM
TRACK No. MIN SEC
PROGRAM
1
9 0
≥10
CLEAR RECALL
Program play
With this function, you can program up to 20 tracks in any order you
like.
1 While the disc is stopped:
Press [PROGRAM].
If the button is pressed while the disc is playing, that track is
programmed as the first.
2 Press the numeric buttons to specify
the track numbers in order.
If you make a mistake when pressing a track number, press
[CLEAR].
3 Press [ ].
Tracks are played in the programmed order, and then play stops
automatically.
Program contents are stored even after play ends.
To play the same program contents again, press [ ].
To cancel program mode
Press [PROGRAM].
To select a two-digit track
Press [≥10] and then the two numbers you want within 7 seconds.
For example
Track no. 25: [≥10] → [2] → [5]
Track no. 30: [≥10] → [3] → [0]
Checking program contents
Press [RECALL].
Each time the button is pressed, a track number and sequence num-
ber are displayed.
To program additional tracks
Press the numeric buttons.
To erase programmed tracks
•To erase the last programmed track
While the disc is stopped:
Press [CLEAR].
One track is erased each time the button is pressed.
•To erase a track within the program
Press [RECALL] to display the track to be erased, and then press
[CLEAR] to erase the displayed track.
•To erase all tracks
While the disc is stopped:
Press [ ].
Program mode is also switched off.
For your reference
“ ” appears on the display:
When 21 tracks have been specified (no further programming pos-
sible).
“ ” appears on the display:
•When the total playing time of the programmed tracks exceeds 99
minutes and 59 seconds.
•When a track numbered 21 or higher has been specified.
In these instances, the total playing time will not be displayed, but
up to 20 tracks can still be programmed.
Number of tracks
programmed
Total playing time of programmed tracks
Last track number
programmed