Tecsun PL-360 User Manual

4
LCD DISPLAY
Battery consumption indicator /
Charging indicator
1
2
Sleep timer indicator
3
Alarm on/off indicator
6
Signal indicators
dBu: signal strength unit
dB : Signal to Noise Ratio
(S/N) unit
7
8
SW meter band indicator
9
ETM indicator
4
Temperature (Temp.)
5
10
11
kHz: frequency unit for
MW& SW
MHz: frequency unit for FM
15
Key-lock indicator
Digital number display (4 Digits)
With radio off: world time, alarm
time, temperature
With radio on: word time, signal
strength / SNR, alarm time,
temperature, local time, memory
address, meter band.
12
14
Digital number display
With radio off: local time
With radio on: frequency display,
band display
FM stereo status indicator
16
Band indicator
Alarm time indicator
Preset memory address
13
Rechargeable batteries indicator
1
2 3 4
5
6
7
8
9
10
14
15
16
13
SLEEP
Temp.
12 11
17
USING THE INTELLIGENT CHARGING FUNCTION
Connect USB 5V to external
power sources
With radio off, install 3 x UM3 (AA) rechargeable batteries
and then press & hold the [ ] key with " " &
" " displays to activate the built in charging function.
1. Use any 5V external adaptor with USB plug to connect
this radio, the symbol " " will advance from the bottom
to top during power charging. It stops when batteries are
fully charged.
2. You can also use any USB cable to connect the radio
with your PC for charging.
Notes for charging power:
1. Insisting to use up all power of rechargeable batteries
before charging again, this could extend the life time of
battery and keeping them in good conditions.
2. 3 pcs of batteries to be used as a group and don't
separate them to other usage. Also don't mix to use
batteries with different power capacity.
Caution: Don't charge on any non-rechargeable batteries in
the radio, this will cause a hazard or damage to your radio.
PL-360

Tecsun PL-360 Specifications

General

Brand	Tecsun
Model	PL-360
Category	Receiver
Language	English