Tecsun S-2000 User Manual

flashing
16
flashing
Note:
If there is no station stored into TIMER A or TIMER B or the station being stored is out, noises
will be heard when the alarm is activated by radio.
STORING A STATION TO TIMER A OR TIMER B
- Turn on the radio and tune to a station that you want to store into
TIMER A or B.
- Long press TIMER A or B ON/OFF button with a "B" sound, note
that " " will flash in the top of the display and then stays in
section TIMER A or B.
SNOOZE
When the alarm is activated, press the SNOOZE button to
temporarily deactivate the timer for 10 minutes, notice that
" " or " " is blinking on the display before the alarm is
activated again. You allow to use 3 times of the SNOOZE
function within the alarm period, after that you can turn off
the alarm by press it again and " " or " " stays.
flashing
" " or " "
the display when snooze is on.
is blinking on
SLEEP TIMER
The sleep timer enables the TECSUN S-2000 to play any length of play time from 1-120 minutes
and then turn off automatically.
To turn on the sleep timer, press the SLEEP button under the
POWER button. Notice that the number of minutes to play
appears in the display, then you can either rotate the TUNING
knob or press / buttons or keep pressing the SLEEP
button to adjust your desired sleep timer. Press again the
SLEEP button or just leave it for about 3 seconds with a long
"B -- " sound to confirm your setting.

Tecsun S-2000 Specifications

General

Brand	Tecsun
Model	S-2000
Category	Receiver
Language	English