6
LISTEN TO THE RADIO
1. Press the POWER button to turn on/off the radio.
2. Select FM by pressing the FM button, MW(AM) and LW by pressing the MW/LW button (press it
twice for LW), SW by pressing the SW button sequentially until you have selected the desired
meter band (meter band number flashes in the upper right corner of the display) and the Aircraft
band by pressing the AIR button.
3. Turn the TUNING knob to your desired radio station.
4. You can also direct key-in the frequency numbers.
5. Adjust the volume, bass and treble tuning knobs for better sound.
Note:
Be sure to fully extend the telescopic antenna when listening to SW, FM and AIR. The swivel AM
antenna is located at the top of the radio; swivel it for best AM (MW/LW) reception.
ATS (AUTO TUNING STORAGE) for FM, MW / LW
To automatically store the strongest LW, MW or FM stations into Page 0.
To activate the ATS function, turn on the radio and fully extend the antenna, then long press the
FM button with a "B" sound and until the frequency number is running on the display. Notice that
page 0 (P0) appears in the display's upper right corner with the presets to the right increasing as
the band is scanned and frequencies are stored into the memory. Once it is done, turn the
TUNING knob to select those stored stations.
MW/LW ATS is same as the FM ATS.
STORING FREQUENCIES INTO MEMORY
To store a frequency into the next available memory on the page that you've selected, press the
MEMORY button with a "B" sound. Note that PRESET flashes with the next available memory
number. Press the MEMORY button with a long "B --" sound to automatically store it into the next
available memory or when it stops flashing it's stored into the memory number that was flashing.
LISTENING TO WHAT'S STORED
1. Turn on the radio and go to the correct page by pressing PAGE and entering it with the numeric
keypad.
2. Press and release the VM/VF button and notice that the PAGE and PRESET show in the
display’s upper right corner.
3. To go from one memory to another give a quick, short press to either the / tuning buttons,
or use the tuning knob.
3. To auto-scan memory press one of the / tuning buttons for about 2 seconds and notice
that PRESET flashes. the radio scans form one memory to another, staying on each memory
for about 5 seconds. To stop the scan, give the / tuning button a quick, short press.
5. Moreover, you can also direct enter the address numbers within its page.
To Next Page
Need help?
General
