13
BBK-V.122018_ENG People First...
EVERLASTING COMPANY
EVERLASTING
WE
COMPANY
AREYOUR
EVERLASTING
WE
COMPANY
AREYOUR
1.8.Electrical Equipment and Connections
Cable classification and connections of a generator set should be made and checked by only trained and qualified
electricians.
Do not touch the electrical hardware of the generator set directly with you bare hands or with the help of any
conducting material.
Before connecting or disconnecting power cables, or before starting the generator set, make sure that the
generator set is properly grounded in accordance with all related rules and regulations.
Do not run, connect or disconnect the generator set underwater or on a wet ground. Remind the conductivity of
water.
Before establishing any electrical connection to the generator set; first stop the engine, then remove the supply
connection from the charger input, then remove all battery connections and finally remove all non-grounded
conductor connections at the load side.
Avoid touching the electrical and moving parts of the generator set with bare hands or any tool. Also be sure that
you are standing on a dry and insulated ground if you have to touch them (electrical installation or equipment) for
any repair or maintenance purposes.
Be sure to keep the insulators at the alternator output on their places. Put them back to their places right after
any connection or disconnection activity. Do not run the generator set if these insulators are not mounted on their
places.
Close and lock all the doors if the generator set is out of service, so nobody unauthorized can get in the generator
set.
Keep the towing truck and equipment at least 3 meters away from the generator set and the power cables.
Perform any repair, maintenance or service activity in clean, dry, well illuminated and ventilated areas.
Be sure that the load connected is proper, according to the loading characteristic and capacity of the generator set.
Do not load the generator set more than its loading capacity. Also ensure that the power cables used between the
load side and generator set are at proper rating and specifications in accordance with related rules and regulations.
Never connect or disconnect electrical cables or equipment in case of gas leakage on supply line or the generator
set.
To Next Page
Loading...
Need help?
General