24
BBK-V.122018_ENG People First...
EVERLASTING COMPANY
EVERLASTING
WE
COMPANY
AREYOUR
EVERLASTING
WE
COMPANY
AREYOUR
3-INSTALLATION
3.1.Selecting Room Location
The selection and preparation of the location that the generator set will be placed is the most important step of
installation. So please make sure that the generator set is installed at a place that is selected and prepared fully in
conformity with the instructions in this manual. Also remember that you can call us for any further information of
confirmation about this issue.
If the generator will be placed on an upper floor not the basement or ground, the responsibility of static load
distribution belongs to customer. The customer should get an approval from an authority about this issue before
installation.
Install generator set in such a place that it will not be directly exposed to harsh environmental conditions as rain,
snow, hail, flood, humidity, excessive sunlight, extremely low or high temperature, dust, soil, sand or wind.
The place that the generator set will be installed must be, clean, dry, well illuminated and ventilated, free of
corrosive or conductive pollutant substances like dust, lint, smoke, oil vapour, exhaust smoke, etc...
Be sure to leave enough blank space around the generator set, in order to ease future maintenance or repair
activities Remember that it can be necessary to disassemble the main parts like engine, alternator or the base
frame in some cases.
The base ground that the generator will be settled, must be clean dry and must have a well drainage system.
Put the generator set at such place that nobody unauthorized can access it, or at least take necessary precautions
about it.
Place generator sets at such places that they will not be effected by the operation of any other machines.
Do not install or run the generator set at any place that has any possibility of risk in terms of safety of operation.
Also provide the necessary precautions (canopy option) or protections against bad weather conditions if it will be
placed outside.
The doors of the room that the generator set will be placed in, must be at an enough size for the main parts
(engine, alternator, radiator, etc…) to pass through. Also ventilation windows can be built portable or mobile for
this purpose.
To Next Page
Loading...
Need help?
General