Configure the instrument
Set the time zone and clock readout format
Set the time zone to your region so that saved files are marked with the correct date and time information. You can also set the
time format (12 or 24 hour clock).
1. Double-tap the Date/Time badge (bottom-right of screen) to open the configuration menu.
2. To turn off showing the date and time on the screen, tap the Display button to Off.
To turn on date/time display again, double-tap in the blank area where the date/time badge was displayed to open the
configuration menu, and set the Display button to On.
3. Select a time format (12 Hour or 24 Hour).
4. Tap the Time Zone field and select the time zone that applies to your location.
5. Tap anywhere outside of the menu to close it.
Download and install the latest 4 Series MSO firmware
Installing the latest firmware helps ensure that your oscilloscope is taking the most accurate measurements.
Prerequisite: Save any important on-instrument files (waveforms, screen captures, setups, and so on) to a USB drive or network.
The installation process does not remove user-created files, but it is a good idea to back up important files before an update.
Prerequisite: Determine the current version of firmware installed on the oscilloscope (see Help > About).
Update oscilloscope firmware from a USB drive
1. Open up a Web browser on a PC and go to www.tek.com/product-support.
2. Enter the oscilloscope model number in the search field and click Go.
3. Scroll down the screen and click the Software tab.
4. If the listed available firmware version is newer than what is on your oscilloscope, select and download that file to your PC.
5. Follow the installation instructions that came with the downloaded firmware to create the firmware install file or files.
6. Copy the firmware install file or files to a USB flash drive.
7. Follow the instructions that came with the downloaded firmware to install the firmware on the oscilloscope.
8. To confirm that the firmware was updated, tap Help > About in the Menu bar and verify that the firmware version number
listed on the screen is the same version that you downloaded.
MSO44, MSO46 Installation and Safety Manual 31
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
Need help?
General
