]
]
J
J
l
l
J
l
SAVE RANDOM EVENTS
1.
Obtain a Storage Display using steps 1 through
4,
with a test signal similar
to
a random event. Use the FAST
mode,
not
VAR PERS.
2.
Set
the
SAVE INTEN control
fully
ccw.
3.
Replace the test signal with the random event.
4.
Push the ERASE button.
5.
When the READY lamp comes on,
but
before the
random event occurs, push the SAVE button.
6.
After the random event
occurs
and is stored, the
storage
circuitry
will automatically
switch
to
the SAVE
mode.
REDUCED SCAN STORAGE (466 ONLY)
To
obtain a greatly increased
writing
rate, pull
out
on
the INTEN control to operate the 466 in the reduced scan
mode. In the reduced scan mode the instructions
for
obtaining storage displays are unchanged. The
only
difference in operation
is
that the deflection factors are
referenced to the smaller graticule in the center
of
the
crt
(see item
11
b in the Controls, Connectors, and Indicators
section
of
this manual). All measurements should be made
within this smaller graticule when operating in the reduc-
ed scan mode.
@
466/464 DM44 Operators
23
To Next Page
Loading...
Need help?
General
