Tektronix DPO2012 Programmer's Manual

Commands Listed in Alphabetical Order
Syntax
TRIGger:A:LOG
Ic:INPut:CLOCk:EDGE {FALL|RISe|EITher}
TRIGger:A:LOGIc:INPut:CLOC k:EDGE?
Arguments
RISe specifies to trigger on the rising or positive edge of a signal.
FALL specifies to trigger on the falling or negative edge of a signal.
EITher specifies to trigger either on the falling or rising edge of a signal.
TRIGger:A:LOGIc:INPut:CLOCk:SOUrce
Sets or returns the channel to use as the clock source. The clock can be selected as
NONE. A selection of None implies pattern trigger. Any other selection implies
state trigger.
Group
Trigger
Syntax
TRIGger:A:LOGIc:INPut:CLOC k:SOUrce {CH1|CH2|CH3|CH4 |
D0|D1|D2|D3|D4|D5|D6|D7|D8 |D9|D10|D11|D12|D13|D14|D15|NONE}
TRIGger:A:LOGIc:INPut:CLOC k:SOUrce?
Arguments
CH1–CH4 specifies the analog input channel source.
D0–D15 specifies the digital input c hannel source.
NONE specifies a Pattern trigger.
TRIGger:A:LOGIc:INPut:D<x>
Sets or returns the logic pattern for a trigger on digital channel <x>, where x
is t
he channel number.
Group
Trigger
Syntax
TRIGger:A:LOGIc:INPut:D<x> {HIGH|LOW|X }
TRIGger:A:LOGIc:INPut:D<x> ?
Arguments
High specifies the logic high state.
Low specifies the logic low state.
X specifies a "don't car e" sta te.
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-321

Tektronix DPO2012 Specifications

General

Brand	Tektronix
Model	DPO2012
Category	Test Equipment
Language	English