Tektronix DPO2012 Programmer's Manual

Commands Listed in Alphabetical Order
BUS
Sets or returns the parameters for each bus. These parameters affect either the
Serial Trigger Setup or the Bus Display.
Conditions
This command requires a DPO2AUTO, DPO2EMBD, or D PO2COMP application
module.
Group
Bus
Syntax
BUS
BUS:B<x>:CAN:BITRate
Sets or returns the bit rate for CAN bus <x>, where x is the bus number.
Conditions
This command requires a DPO2AUTO applic ation module.
Group
Bus
Syntax
BUS:B<x>:CAN:BITRate <NR1>
BUS:B<x>:CAN:BITRate?
Arguments
<NR1> sets the bit rate to the closest bit rate supported by the instrument.
Returns
The query always returns the numerical bit rate value.
BUS:B<x>:CAN:PRObe
Sets or returns the probing method to probe CAN bus <x>, where x is the bus
number.
Conditions
This command requires a DPO2AUTO applic ation module.
Group
Bus
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-73

Tektronix DPO2012 Specifications

General

Brand	Tektronix
Model	DPO2012
Category	Test Equipment
Language	English