Tektronix DPO2012B Programmer's Manual

Commands Listed in Alphabetical Order
Arguments
RI specifies sig
ned integer data point representation.
RP specifies positive integer data point representation.
Examples
WFMOUTPRE:BN_FMT RP specifies that outgoing waveform data will be in positive
integer format.
WFMOUTPRE:BN_FMT? might return :WFM OUTPRE:BN_FMT RI indicating that
the outgoing waveform data is currently in signed integer format.
WFMOutpre:BYT_Nr
Sets or returns the data width for the outgoing waveform specified by the
DATa:SOUrce command. Changing WFMOutpre:BYT_Nr also changes
WFMOutpre:BIT_Nr and DATa:WIDth.
Group
Waveform Transfer
Syntax
WFMOutpre:BYT_Nr <NR1>
WFMOutpre:BYT_Nr?
Related Commands
DATa:SOUrce, DATa:WIDth, WFMOutpre:BIT_Nr
Arguments
<NR1> is the number of bytes per data point and can be 1 or 2.
Examples
WFMOUTPRE:BYT_NR 1 sets the number of bytes per outgoing waveform d ata
point to 1, which is the default setting.
WFMOUTPRE:BYT_NR? might return :WFMOUTPRE:BYT_NR 2 indicating that
there are 2 bytes per outgoing waveform data point.
WFMOutpre:BYT_Or
Sets or returns which byte of binary waveform data is transmitted first, during
a waveform data transfer, when data points require than one byte. This
specification only has mean ing when WFMOutpre:ENCdg is set to BIN and
WFMOutpre:BYT_Nr is 2. Changing WFMInpre:FILTERFreq also changes
DATa:ENCdg (if DATa:ENCdg is not ASCIi).
Group
Waveform Transfer
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-365

Tektronix DPO2012B Specifications

General

Brand	Tektronix
Model	DPO2012B
Category	Test Equipment
Language	English