Tektronix DPO4032 User Manual

Installation
6. On the side-bezel menu, if you are on a
DHCP Ethernet network and using dynamic
addressing, set DHCP to On. If you are using
static addressing, set it to Off.
Change
Instrument
Settings
Push Change Instru ment Setting s.Ifyou
are using DHCP, note the Ethernet address
and instrument name. If you are using Static
addressing, enter the E thernet address you
will be using.
DHCP/
BOOTP
On|Off
Test
Connection
NOTE. Depending on the type and speed of
network to which your 4000 Series oscilloscope is
connected, you may not see the DHCP/BOOTP
field update instantaneously after pressing the
DHCP/BOOTP button. It may take a few seconds
to update.
MSO4000 and DPO4000 Series Oscilloscopes User Manual 51

Tektronix DPO4032 Specifications

General

Brand	Tektronix
Model	DPO4032
Category	Test Equipment
Language	English