Tektronix MDO3024 User Manual

Use the Arbitrar
y Function Generator
If needed, push AFG > Waveform Edit to bring
up the waveform edit lower menu.
5. Push Edit Existing to change, add, or delete
points in a cu
rrent waveform.
Edit
Existing
Create
New
Load
Waveform
Freq.
Ampl.
Offset
100.00kHz
500.00m-
Vpp
0.000 V
Period
10.000 s
High
250.00mV
Low –250.
00mV
Save
Waveform
When you enable the internal editor, the screen
splits into
a smaller top window and a larger
bottom window.
The smaller, top part of the screen becomes
an overvie
w, which shows the entire waveform
memory. A box shows the zoomed-in portion of
the waveform.
The large
r, lower part becomes the zoomed-in
view of the overview, as defined by the box in the
top part of the screen. This lower part shows up
to 500 poi
nts of the record.
Turn the Multipurpose a knob to select a point
to edit.
Turn the
Multipurpose b knob to set the voltage
level of that point. The voltage level is a function
of the current amplitude and offset settings for
the wav
eform.
Use the side menu items to add or remove points
from the waveform.
6. Push Create New from the lower-menu to
make a fresh arbitrary waveform.
On the
resulting side menu, turn
Multipurpose a or use the keypad to defi ne
the number of points in the waveform. Your
wave
form can have up to 131,072 points.
Turn Multipurpose b to choose the basic
function. Choose between square, sine,
ramp
, pulse, and noise.
Push OK Create to build the new waveform.
188 MDO3000 Series Oscilloscopes User Manual

Tektronix MDO3024 Specifications

General

Brand	Tektronix
Model	MDO3024
Category	Test Equipment
Language	English