Installation
4. P ower on the osc
illoscope. The instrument
automatically recognizes the replacement
firmware and installs it.
If the instrum
ent does not install the
firmware, rerun the procedure. If the
problem continues, try a different model of
USB flash or ha
rd drive. Finally, if needed,
contact qualified service personnel.
NOTE. Do not power off the oscilloscope or
remove the US
B drive until the oscilloscope
finishes installing the fi rmware.
5. P ower off the oscilloscope and remove the
USB fl ash or hard drive.
6. P ower on the oscilloscope.
7. Push
Utility.
24 MDO3000 Series Oscilloscopes User Manual
To Next Page
Loading...
Need help?
General
