Service Information
10
P6021 Instruction Manual
Table 4: Certifications and compliances (Cont.)
Installation Category Descriptions
Terminals on this product may have different installation category
designations. The installation categories are:
CAT III Distribution-level mains (usually permanently
connected). Equipment at this level is typically in a
fixed industrial location
CAT II Local-level mains (wall sockets). Equipment at this
level includes appliances, portable tools, and similar
products. Equipment is usually cord-connected
CAT I Secondary (signal level) or battery operated circuits
of electronic equipment
Pollution Degree 2 Do not operate in environments where conductive
pollutants may be present.
Typical Characteristics
This section lists the various typical characteristics that describe the P6021
Current Probe. Included are typical electrical and mechanical characteristics.
Typical characteristics are described in terms of typical or average performance.
Typical characteristics are not warranted.
Table 5: Electrical characteristics
Characteristic Information
Tilt
2 mA/mV 2.8% or less within 10
m
s of step
10 mA/mV 7.5% or less within 100
m
s of step
Maximum DC saturation 0.5 A
Signal Delay
5-foot probe with termination Approximately 9 ns
9-foot probe with termination Approximately 15.8 ns
Insertion Impedance 0.03
W
or less at 1 MHz, increasing to 1.0
W
or less
at 60 MHz
To Next Page
Loading...
Need help?
General
