Installation instructions
Installation instructions
This section contains all procedures needed to install the required components.
Minimum tool
and equipment list
The following tools are required to for installation of this k it. All tools are
standard tools that are readily available.
Item Name Description
1.
Screwdriver handle (magnetic)
Torque driver. Accepts 14 inch
hex-head driver tips
2.
T8 TORX tip TORX driver tip for T-8 size screw
heads
3.
T15 TORX tip TORX driver tip for T-15 size screw
heads
4.
T20 TORX tip TORX driver tip for T-20 size screw
heads
5.
5/8" hex wrench Open end wrench to install BNC
connector
6.
5/32" hex wrench
NOTE. Only needed for early models
of the RSA5100A Series instruments.
Hex wrench to remove Allen head
screws at front of top cover
These instructions are for qualified service personnel who are familiar
with servicing the product. If you need further details for disassembling or
reassembling the product, refer to the product’s Service Manual.
Rem
ove cosmetic covers and shield
NOTE. Right-side or left-side references in these instructions assume you are
viewing the instrument from the front panel.
WARNING. To avoid electric shock, switch off the instrument power, then
disconnect the power cord from the mains power. Failure to do so can cause
injury or death.
1. Remove the power cord.
2. If it is installed, pull the front cover off the instrument.
4 RSA5100A/B Series Digital I/Q and Zero Span U pgrades
To Next Page
Loading...
Need help?
General
