Operation
Changing Measurement Settings
The displays have settings that control how signals are acquired and processed. The settings that you can change depend
on the selected display.
To access the settings (in this case, for the Spectrum display):
1. Click Settings to open the Settings
control panel.
2. Adjust the controls as needed for your
signal or test. For example, use the
Freq & Span tab to set frequency and
span. Most of the control panels have
tabs that provide easy access to other
related controls.
3. You can change the appearance of the
display s
creen in the Prefs tab. Not all
of the following controls apply to every
display. Some displays have additional
controls
not described here.
To turn o
n or off the graticule, select
the Show graticule check box.
To turn on or off the marker readout,
select the Show Marker readout in
graph c
heck box.
To turn
on or off the trace legend,
select the Show trace legend check
box.
Quic
kTip
If you have m ultiple displays on the screen, click anywhere inside one of the other displays to change to the control
panel for that display.
RSA6100A Series & RSA5100A Series Q uick Start User Manual 33
To Next Page
Loading...
Need help?
General
