Tektronix T922 User Manual

PERFORMANCE CHECK
This procedure allows the
basic performance specifications to be
checked without removing theinstrument
covers . It is
intended for use
in incoming inspection to determine acceptability of
newly purchased or recently
calibrated instruments .
Tolerances given are for the
instrument under test and
do not include test
equipment error . Limits and tolerances
in this check are
instrument specifications only if they are
called out as performance requirements
in the
specifications section .
'Requires a TM500 Series Power Module .
REV . B, DEC .
1976
LIMITS AND
TOLERANCES
TABLE 3-1
Test
Equipment
Section 3-T921/T922/T922R
TEST EQUIPMENT
REQUIRED
You will
need the test equipment listed in
Table 3-1, or
equivalent, to
perform a complete
Performance Check of
the
T921, T922, and T922R . The
Specifications given for
the equipment are the
minimum necessary for
accurate
results .
Examples
of Applicable
Description
Minimum Specifications
Usage
Test Equipment
1 . Amplitude Calibrator
Amplitude accuracy, within
Vertical Gain checks,
a
. Tektronix PG 506 Calibra-
0.5% ; signal amplitude, 10
mV X gain check .
tion Generator .'
to 10 V ; output
signal, 1 kHz
square wave
.
b .
Tektronix 067-0502-01
Calibration Fixture .
2 . Sine-Wave Generator Frequency
50 kHz to above
Vertical Amplifier band-
a . Tektronix SG 503
Leveled
15
MHz ; output amplitude
width checks, X bandwidth
Sine-Wave Generator
.'
variable from 0 .5 to 5 V p-p ;
check . Triggering checks .
output impedance, 50 0
;
Z axis input check . b . Tektronix
Type 191
Cons-
reference frequency, 50
kHz ;
tant
Amplitude
Signal
amplitude accuracy,
constant
Generator .
within 0 .3% of
reference
frequency as output frequency
changes .
3 .
Time-Mark Generator Marker
outputs, 20 ns to 0 .5 s ; Timing
checks . a .
Tektronix TG 501
Time-
marker accuracy within 0.5% ;
MarkerGenerator .'
trigger output 1 ms to 0 .1
has,
time coincident with
markers .
b . Tektronix
2901 Time-Mark
Generator
.
4 . Termination Impedance, 50
f2 ; BNC Signal termination . a .
Tektronix Part 011-0049-01 .
connectors .
5 . Cable (3)
Impedance 50 i2 ; BNC Signal
interconnection . a . Tektronix Part
012-0057-01 .
connectors .

Tektronix T922 Specifications

General

Brand	Tektronix
Model	T922
Category	Test Equipment
Language	English