Tektronix T922 User Manual

e .
ADJUST-C4205
(see
Fig . 4-4) for
best
square front
corner (see Fig . 4-5 for example) . Disconnect test equip-
ment .
f . Set CH 2 VOLTS/DIV to 10 mV and X1-X10 to X1 (fully
ccw) .
g . Connect a 10X probe to the CH 2 input . Connect the
probe tip to a probe tip-to-BNC adapter, the adapter to a
50 O BNC termination, and the termination
to
a 50 O BNC
10X attenuator attached
to
the square-wave generator
high-amplitude output connector . Set generator for a 5-
division, 1 kHz display .
h . Compensate probe for best front corner of waveform .
REV . A, JUNE 1976
m .
Disconnect
test equipment .
Adjustments-T921 /T922/T922R
i . Set CH 2
VOLTS/DIV
to 20
mV and
set
generator fora
5-division display (remove 10X attenuator if necessary) .
j . ADJUST-C4213 for flat top on square wave .
k .
Set CH 2 VOLTS/DIV to .2
V,
and square-wave
generator output for a 5-division display (remove 10X
attenuator, and also 50 S2 termination if necessary) .
I . ADJUST-C4204 for a flat top on square wave .
4- 9

Tektronix T922 Specifications

General

Brand	Tektronix
Model	T922
Category	Test Equipment
Language	English