TAS 200 Series Specifications
Bench Test Instruments and Handheld Oscilloscopes Basic Service
5
Table 4: Trigger characteristics
Characteristic TAS 220 description TAS 250 performance description
Sensitivity
0.5 divi sions (int ernal), 0.1 V (external) DC to 5 MHz DC to 10 MHz
1.5 divi sions (int ernal), 0.2 V (external) 5to20MHz 10 to 50 MHz
2.0 divi sions (int ernal), 0.2 V (external) Video Video
Input I mpedance (Typical) 1MΩ,30pF
Maximum Input Signal 100 V (DC + peak AC)
Table 5: Typical Z-Axis characteristics TAS 200 series
Characteristic Description
Maximum Input Voltage 50 V (DC + peak AC)
Sensitivity 3V
p-p
(Trace becomes brighter with negative input. )
Frequency Bandwidth DC to 5 MHz
Input Resi stance 5kΩ
Table 6 : Typical X-Y mode operation
Characteristic TAS 220 description TAS 250 description
Sensitivity Same as CH 1 vertical axis
Sensitivity Accuracy 5mVto5V/div: ±4%
1to2mV/div: ±6%
Frequency Bandwidth DC to 1 MHz DC to 2 MHz
X-Y Phase Di fference ≤3° from DC to 50 kHz ≤3° from DC to 100 kHz
EXT HOR Sensitivity 0.1 V/di v
Table 7: Typical probe com pensation signal characteristics TAS 200 series
Characteristic Description
Waveform Positive going square wave
Frequency 1kHz
Duty Ratio 50:50
Output Level 2V
p-p
Output Resi stance 2kΩ
To Next Page
Loading...
Need help?
General
