To Next Page

To Previous Page

Cursor

Push the Cursor button to display the measurement cursors and Cursor Menu,

and then turn the Multipurpose knob to change the position of a cursor.

Options Settings Comments

Type

Time, Amplitude, Off Select and display the measurement cursors;

Time measures time, frequency, and amplitude;

Amplitude measures amplitude, such as current

or voltage

Source Ch1, Ch2, FFT, Math,

Ref A, Ref B

Choose the waveform on which to take the

cursor measurements

Cursor readouts display the measurement

Δ Displays the absolute value of the difference

(delta) between the cursors

Cursor 1 Displays selected cursor location (time is

referenced to the trigger position, and amplitude

to the reference connection)

Cursor 2

Delta (Δ) values vary with the following types of cursors:

■

Time cursors display Δt, 1/ Δt and ΔV (or ΔI, ΔVV, and so on)

■

Amplitude cursors, and Magnitude cursors (FFT source) display ΔV, ΔI,

ΔVV, and so on

■

Frequency cursors (FFT source) display 1/ΔHz and ΔdB

NOTE. The oscilloscope must display a waveform for the cursors and cursor

readouts to appear.

NOTE. The oscilloscope displays the time and amplitude values for each

waveform when you use Time cursors.

For an FFT source, measures Frequency and Magnitude.

Reference

84 TBS1000B and TBS1000B-EDU Series Oscilloscopes User Manual

Tektronix TBS1022 User Manual

Other manuals for Tektronix TBS1022