Compliance Information
Australia / New Zealand
Declaration of
Conformity – EMC
Complies with t
he EMC provision of the Radiocommunications Act per the
following standard.
CISPR 11 :2003
. Radiated and Conducted Emissions, Group 1, Class A, in
accordance with EN 61326-1:2006 and EN 61326-2-1:2006.
FCC–EMC
Emissions are within the limits of FCC 47 CFR, Part 15, Subpart B for Class A
equipment.
Safety Compliance Information
Table 1: S
afety compliance information
Category Standards or description
EC Declaration o f Conformity – Low
Voltage
1
Compliance was demonstrated to the following specification as listed in the Official Journal
of the European Communities:
Low Volt
age Directive 73/23/EEC, amended by 93/68/EEC.
EN 61010-1/A2:1995. Safety requirements for electrical equipment for measurement
control and laboratory use.
EN 6101
0-2-032:1995. Particular requirements for hand- held current clamps for electrical
measurement and test equipment.
U.S. Nationally Recognized Testing
Laboratory Listing
UL3111-1. Standard for electrical measuring and test equipment.
UL3111-2-032. Hand-held probe assemblies for electrical measurement and test.
UL610
10-1. Safety requirements for electrical equipment for measurement, control, and
laboratory use.
UL61010B-2-032: Particular requirements for hand-held current clamps for electrical
measu
rement and test.
Cana
dian Certification
CAN/
CSA C22.2 No. 61010.1. Safety requirements for electrical equipment for
measurement, control, and laboratory use.
CAN/CSA C22.2 No. 61010.2.032:1996. Particular requirements for hand-held probe
ass
emblies for electrical measurement and test equipment.
Add
itional Compliance
IEC
61010-2-032:1995. Particular requirements for hand-held current clamps for electrical
measurement and test.
IEC 61010-1:2001. Safety requirements for electrical equipment for measurement control
an
d laboratory use.
In
stallation (Overvoltage) Category
Descriptions
Te
rminals on this product may have different installation (overvoltage) category
designations. The installation categories are:
CAT III. Distribution-level m ains (usually permanently connected). Equipment at this level is
t
ypically in a fixed industrial location.
CAT II. Local-level mains (wall sockets). Equipment at this level includes appliances,
portable tools, and similar products. Equipment is usually cord-connected.
C
AT I. Secondary (signal level) or battery operated circuits of electronic equipment.
viii TCPA300/400 Amplifiers and TCP300A/400 Series Current Probes User Manual
To Next Page
Loading...
Need help?
General
