Command Groups
2–20
TDS Family Oscilloscope Programmer Manual
Measurement commands can set and query measurement parameters. You can
assign some parameters, such as waveform sources, differently for each
measurement readout. Other parameters, such as reference levels, have only one
value, which applies to all measurements.
Table 2–14: Measurement Commands
Header Description
%!"' Return all measurement parameters
%!"'$&#' Take down measurement snapshot
%!"' Set or query measurement gating
%!"' Return immediate measurement parameters
%!"'* Return info on immediate delay measurement
%!"'*
' #"
Search direction to use for delay measure-
ments
%!"'* Which waveform edge to use for delay
measurements
%!"'* Which waveform edge to use for delay
measurements
%!"' Channel to take measurement from
%!"' Second channel to take measurement from
(delay or “to” channel)
%!"' The measurement to be taken
%!"''& Return measurement units
%!"'( Return measurement result
%!"') Return parameters on measurement
%!"')* Return delay measurement parameters
%!"')*
' #"
Search direction to use for delay measure-
ments
%!"')* Which waveform edge to use for delay
measurements
%!"')* Which waveform edge to use for delay
measurements
%!"') Channel to take measurement from
%!"') Second channel to take measurement from
(delay or “to” channel)
%!"') Turn measurement display on or off
%!"') The measurement to be taken
%!"')'& Return units to use for measurement
To Next Page
Loading...
Need help?
General
