Tektronix TDS 700A Programming Manual

Command Groups
TDS Family Oscilloscope Programmer Manual
2–21
Table 2–14: Measurement Commands (Cont.)
Header Description
MEASUrement:MEAS<x>:VALue? Return measurement result
MEASUrement:METHod Method for calculating reference levels
MEASUrement:REFLevel? Return reference levels
MEASUrement:REFLevel:ABSolute:HIGH The top level for risetime (90% level)
MEASUrement:REFLevel:ABSolute:LOW The low level for risetime (10% level)
MEASUrement:REFLevel:ABSolute:MID Mid level for measurements
MEASUrement:REFLevel:ABSolute:MID2 Mid level for delay measurements
MEASUrement:REFLevel:METHod Method to assign HIGH and LOW
levels: either % or absolute volts
MEASUrement:REFLevel:PERCent:HIGH The top level for risetime (90% level)
MEASUrement:REFLevel:PERCent:LOW The low level for risetime (10% level)
MEASUrement:REFLevel:PERCent:MID Mid level for measurements
MEASUrement:REFLevel:PERCent:MID2 Mid level for delay measurements
MEASUrement:SNAPShot Display measurement snapshot
Miscellaneous Commands
Miscellaneous commands do not fit into other categories. Table 2–15 lists these
commands.
Several commands and queries are common to all 488.2–1987 devices on the
GPIB bus. The 488.2–1987 standard defines them. They begin with a star (*)
character.
Table 2–15: Miscellaneous Commands
Header Description
AUTOSet Automatic instrument setup
BELl Audio alert
*DATE Set date
*DDT Define group execute trigger (GET)
FACtory Reset to factory default
HDR Same as HEADer
HEADer Return command header with query
*IDN? Identification

Tektronix TDS 700A Specifications

General

Brand	Tektronix
Model	TDS 700A
Category	Test Equipment
Language	English