To Next Page

To Previous Page

Table of Contents

TDS Family Oscilloscope Programmer Manual

iii

List of Figures

Figure 1–1: Common Message Elements 1–1. . . . . . . . . . . . . . . . . . . . . . .

Figure 1–2: Functional Groupings and an Alphabetical List of

Commands 1–2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure 1–3: Service Requests (SRQs) Provide for Event (Interrupt)

Driven Programs 1–2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure 1–4: The Disks That Accompany This Manual 1–3. . . . . . . . . . . .

Figure 1–5: GPIB Connector Location 1–3. . . . . . . . . . . . . . . . . . . . . . . . .

Figure 1–6: How to Stack GPIB Connectors 1–4. . . . . . . . . . . . . . . . . . . .

Figure 1–7: Typical GPIB Network Configurations 1–5. . . . . . . . . . . . . .

Figure 1–8: Selecting the I/O System in the Main Menu 1–5. . . . . . . . . . .

Figure 1–9: Selecting the GPIB Address in the GPIB Configuration

Side Menu 1–6. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure 2–1: Command Message Elements 2–2. . . . . . . . . . . . . . . . . . . . . .

Figure 2–2: Block Argument Example 2–9. . . . . . . . . . . . . . . . . . . . . . . . .

Figure 2–3: Typical Syntax Diagrams 2–10. . . . . . . . . . . . . . . . . . . . . . . . . .

Figure 2–4: Message Window Coordinates 2–197. . . . . . . . . . . . . . . . . . . . . .

Figure 2–5: LESSThan and MOREThan Arguments 2–239. . . . . . . . . . . . .

Figure 3–1: The Standard Event Status Register (SESR) 3–2. . . . . . . . . .

Figure 3–2: The Status Byte Register (SBR) 3–2. . . . . . . . . . . . . . . . . . . . .

Figure 3–3: The Device Event Status Enable Register (DESER) 3–3. . . .

Figure 3–4: The Event Status Enable Register (ESER) 3–4. . . . . . . . . . . .

Figure 3–5: The Service Request Enable Register (SRER) 3–4. . . . . . . . .

Figure 3–6: Status and Event Handling Process 3–6. . . . . . . . . . . . . . . . .

Figure 3–7: Command Processing Without Using Synchronization 3–8.

Figure 3–8: Processing Sequence With Synchronization 3–8. . . . . . . . . . .

Figure 4–1: Equipment Needed to Run the Example Programs 4–1. . . . .

Tektronix TDS 700A Programming Manual

Other manuals for Tektronix TDS 700A